![]() This sets the client as the Windows system e-mail client.Įnter your e-mail information as required.Į-mail client configuration settings should automatically be set during installation. Select “Use this client as default application” option when prompted. The Data Manager e-mail feature uses the Windows system e-mail client. Install the software following the screen prompts. See Email for information on sending e-mails from Data Manager.Į-mail client installation and setup (Example): 1.ĭownload an email client (e.g. ![]() The following instructions are intended as a guide only, as e-mail client setup procedures vary. ![]() To use this feature, you must install an e-mail client, and then link your existing e-mail address to the client. The Data Manager function features an e-mail option that allows you to send a saved data or image files as an e-mail attachment. Depending on settings, you may need to select your user ID icon to open the last application. The display screen will turn on and resume the last open application. The display screen will turn off, and the Battery Status Indicator located in the power button will light up red, blinking on and off at two second intervals.Ī blinking Red indicator (on and off at two second intervals) indicates the diagnostic tool is in Sleep Mode. If Sleep Mode is accidentally activated during active vehicle communication, vehicle communication will stop, vehicle selection will be reset to “no active vehicle” and the Home screen is displayed. It is recommended that you terminate current vehicle communication and save any open working files or data before entering Sleep Mode, to avoid ECM problems (on some vehicles) or data loss from unforeseen circumstances (e.g. For additional information, refer to Windows 10 user documentation. Sleep Mode settings can be found in Windows Control Panel > Power Options. When you are ready to resume work, the diagnostic tool can be started up again quickly, just by pressing the Power button. The Windows operating system uses Sleep Mode to conserve power by stopping all processes and turning off the display screen, while keeping the diagnostic tool on and your open applications active. Also refer to Pen and Touch settings in the Windows Control Panel for additional information and settings. For additional information on Windows touch screen operations, see Windows 10 and Windows “Touch Gesture” user documentation. The information provided in the above table is not inclusive, may vary and is intended as a general guide only. Open alternate menus (similar to right click). Touch a point, then while maintaining light pressure, tap (in the same general area) with another finger. In a quick and continuous motion, select a point and quickly swipe in the desired direction while lifting off the screen. Touch a point, then while maintaining light pressure, drag in the desired direction. Touch a point and maintain light pressure. Zoom the display in or out, to make a selection (e.g. Touch two points, then move your fingers toward or away from each other. Quickly tap a point (once), then release. The terms used to describe the various gestures may vary (industry wide), however the general procedures and usage are similar for specific operations. pinch-to-zoom, press and tap, pan and swipe). This device uses common touch screen gesture motions (e.g. There are two styles of removable stylus tips. Stylus tip replacement - see Periodically the capacitive stylus tip may need to be replaced. Touch screen maintenance - see Care and Cleaning Touch screen calibration - see Calibrating the Touch Screen Detailed descriptions of the menu structures are found in the sections for the various functions.įor information on touch screen calibration, maintenance and stylus tip replacement: Most operations are menu driven, which allows you to quickly locate the test, procedure, or data that you need through a series of choices and questions. The capacitive touch screen also provides you with multi-touch gesture capabilities found on common surface touch devices. Simply touch the screen with your finger, or use the capacitive stylus to make a selection. The capacitive touch screen is used to control almost all the operations of the diagnostic tool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |